Thermoweb-Deco Foil Adhesive Pen. Deco Foil adhesive pen is a permanent adhesive designed to make applying foil to paper even easier! Simply hand-draw or stencil a design on your paper project, cover with foil, then use either a die-cutting machine to pressure set, or a laminator to heat set. This package contains one 0.34oz permanent adhesive pen and one extra tip. Acid free. Imported.
Features & Benefits:
.34 fl oz (10mL)
Permanent
Acid Free
Works great with Deco Foil Designer Stencils
Use exclusively with: Deco Foil™ Transfer Sheets
Directions: Always pre-test for best results....
Show More
Thermoweb-Deco Foil Adhesive Pen. Deco Foil adhesive pen is a permanent adhesive designed to make applying foil to paper even easier! Simply hand-draw or stencil a design on your paper project, cover with foil, then use either a die-cutting machine to pressure set, or a laminator to heat set. This package contains one 0.34oz permanent adhesive pen and one extra tip. Acid free. Imported.
Features & Benefits:
.34 fl oz (10mL)
Permanent
Acid Free
Works great with Deco Foil Designer Stencils
Use exclusively with: Deco Foil™ Transfer Sheets
Directions: Always pre-test for best results. First-time use, press down and hold adhesive tip in for 30 seconds or until adhesive starts to flow. Repeat if necessary. Replace cap after use. Use smooth paper for best results.
1. Freehand or stencil with Adhesive Pen, moving pen slowly. Let adhesive dry for approximately 30 seconds to 1 minute.
2. Cut a piece of foil slightly larger than design. Place foil, color side facing up, on top of design.
3. Apply foils to the Adhesive Pen design.
Option 1-Laminator*: Turn on laminator, select 5mil setting and allow 10-minutes to warm up. When ready, place foil-covered adhesive design inside folded piece of parchment paper and place project into laminator, using crease as lead edge. Remove project from parchment paper and peel transfer sheet away from design.
Option 2-Die Cutting Machine: Place foil-covered adhesive design inside folded piece of cardstock. Run through die cutting machine, using same set-up as for wafer-thin dies. Remove project from cardstock and peel transfer sheet away from design. Die cutting machines vary, adjustments may be necessary. Directions are based on Royal Sovereign laminator model # CS923/1223. Other brands/models, temperature and speed settings may vary.
Show Less